Robertshaw 300-204 Uživatelská příručka stáhnout pdf

TECHNICAL APPLICATION

Programmable and non-programmable thermostats with

solid state equipment outputs require a minimum of 80

mΑ ac (0.08A) of current draw to ensure switching

integrity.

The 300 Ω 5 watt resistor (supplied) should be installed

on the equipment terminal strip in accordance with the

drawing below to increase the current draw of the

primary control to 80 mΑ or greater. This connection

should eliminate any incompatibility problems between

the thermostat and the system.

INSTALLING THE RESISTOR

1. Read the instructions carefully. Failure to do so may

damage the product or cause a hazardous condition.

2. Check the rating on the resistor to make sure the

size (rating) is correct.

3. The installer must be a qualified service technician.

4. Connect the resistor leads to the equipment termi-

nal strip across the W, Y or G (as required) and

24VAC Common terminals. Avoid contact with any

other terminals or components within the equip-

ment.

Connect either end of the resistor to the terminals

(non-polarized) and firmly tighten the screw terminals.

WARNING!

The resistor will become warm during equipment

operation. This is normal.

110-856

TECHNICAL APPLICATIONProgrammable and non-programmable thermostats withsolid state equipment outputs require a minimum of 80 mΑ ac (0.08A) of current

Žádné komentáře

Robertshaw 300-204 Uživatelská příručka